1. Filling lubricating oil to linear guide
As we know, the smoke and dust which is produced by the inscription and cutting will hurt the guide rail after a period of usage, so we need to do the day-to-day upkeep of the guide rail. Please switch off the laser engraving machine and cut the power, tidy the guide rail with clean mull, then please drop the lubricating oil on the guide rail, try to move the slide rod and make certain that the oil enters into it. Make the slide rod carry on the guide rail after filling the oil, now we need to install the guide rail to start with, please do not fix the guide rail to start with, set up the screws in the ideal position and keep the slide ray on the even level. Then fix the belt and slide rod well, set up the lens then change the location of X light.
2. Clean the reflector and focusing mirror
After a period of use of the laser engraving and laser cutting maker, the smoke and dust will abide by the surface of the reflector and mirror, which will affect the inscription and cutting depth and also will affect the inscription and cutting accuracy. We need to clean the three reflectors and one focusing mirror with pure alcohol weekly.
3.Oil-filling for the bearing
A laser engraving machine is geared up with great deals of bearings, in order to keep the good inscription and cutting outcome, part of bearings have to be refilled with oil frequently (except the oil-retaining bearing). Rub out the surface area dust on the bearing with the clean mull, take a piece of injector and draw some engine oil inside, then fill the bearing with pinhead and move the bearing at the exact same time.
4. Change of synchronous belt
There are some simultaneous belts on one laser engraving machines, if the concurrent belt is too loose which will lead to the double pictures of the engraved words, if the simultaneous belt is too tight which will lead to the abrasion of synchronous belt. After a duration of usage, please change the tight screws of synchronous belt, change the simultaneous belt until its degree of tightness appropriates, it is appropriate when there is no double pictures of the personalized words and the sound of the laser inscription and laser cutting device is very low, or you can consult our professional.
5. Maintenance of the laser tube
The laser tube of the laser engraving machine is utilizing the cycle water as cooling system and as the time goes on, there will be some furings inside the laser tube. We we can put a little vinegar into the cycle water, the vinegar will melt the furing. After that, we will utilize some clean water to clean up the tube. So the laser tube will be in the very best working condition and its life will end up being longer.
If you are looking for more information on laser engraving machine, please visit: http://www.stylecnc.com.